|
||||
 |
||||
 |
||||
| ˇˇ | ˇˇ | SBX FEATURES | ||
 |
||||
| Size: | 72.4x94mm | |||
| I/O Type: | Digital | |||
| Point: | 48 | |||
| Bus External: | SBX | |||
| Connect to rack: | Ribbon Cable | |||
| Connectors: | 2 (each 24 point) | |||
| Support Controller: | MicroDAC | |||
| Extend BUS support: | SBX Specification | |||
| Network Protocol: | Support OptoMux | |||
|
|
 |
Commands Support: | Superset | |
| Replace 72-SBX-48PIO, The EINDOS-SBX-48PIO is a digital SBX Extender board, which can work with Grayhill MicroDAC to extend 48 point digital I/O. Ribbon Cable to two additional 24 position racks, increase I/O per MicroDAC to 80. | Compatible: | 72-SBX-48PIO | ||
| ZSBX31 (ZIATECH) | ||||
| Humidity: | 95% non-condensing | |||
|
In applications where there are high concentrations of I/O at some of the locations,this board decreases the number of MicroDAC required by increasing the number of I/O managed by each MicroDAC. |
Operating Temp. | -40 ˇăC to +85 ˇăC | ||
| Storage Temp. | -50 ˇăC to +90 ˇăC | |||
| The 48 PIO board plugs into the SBX connector on MicroDACs.the board fits under the aluminum cover and ribbon cables are routed through the knock panel on the cover to additional racks of digital I/O. The rack can be 8, 16, or 24 position racks located within 6 feet of the MicroDAC. | ˇˇ | |||
|
||||
|
An ECP program executing on the MicroDAC can be used to control or monitor the status of the remote I/O, or all 48 points of digital I/O can be accessed with extended ProWare commands over the network. |
||||
| EINDOS-SBX-48PIO support OptoMux Superset commands and network protocol drivers. Not only the board can work with Grayhill MicroDAC together, But also can be used in any system which have SBX extend interface. | ||||
| ˇˇ | ||||